Nanotechnology for cement surfaces, mortar, grout,
stucco and natural or artificial stones.
SurfaPore C formulation creates a water repelling
protection by deeply penetrating into the pores of
the substrates, instead of sealing them compared to
conventional formulations. Therefore, the substrate
is deeply protected and not affected by abrasion or
mechanical wear. SurfaPore C modified surfaces last
longer comparing to conventional film coatings and
are more resistant to the "hard" part of solar light
(UV radiation) which does not induce the "yellowing"
effect.
GENERAL CHARACTERISTICS
SurfaPore C is a water based, liquid formulation
that provides water repellency and protection of a
wide range of building surfaces. As its viscosity is
similar to water, it deeply penetrates into
capilaries that no elastomer or polymer can reach.
The nanotechnology based composition assures effectiveness,
prolonged lifetime, no change of the original
natural appearance and "breathability" of the modified
surface. In case moisture is trapped or a water
leakage takes place behind a SurfaPore C modified
surface, water can evaporate through the open pores
to the environment relieving negative capillary
pressure. In this manner swelling and cracking of
material are prevented and surfaces remain dry and
unchanged in both appearance and mechanical
properties.
APPLICATION SURFACES
Natural and artificial stones, walls, basements,
rooftops, render, stucco, tile grout
APPLICATION NOTE
Surface
Application: The
application surface should be dry and clean. Apply
SurfaPore C by using a brush, roller or spraying. No
dilution is required. On very absorptive surfaces
re-apply within 3 hours.
Mixing: Replace
1/3 of water used in your mix with SurfaPore C. Mix
well. In any case (surface application or mixing)
test results on a small area before full scale
application. Maximum water repellency is achieved 24
hours post application.
Consumption: Estimated
consumption rate 8-10 m²/L, strongly dependant on
the properties of the surface applied.
